Rear suspension
R-12
Removal/installation of rear helical spring
1. Remove the rear shock absorber assembly (See
the Removal/Installation of Rear Shock
Absorber)
2. Remove in the order as shown in the Table.
3. Install in the reversing order of removal.
1 Helical spring
2 Upper rubber mat of helical spring
Installation notes of rear helical spring
1. After the bolt connecting the rear shock absorber
with the rear tow arm released，pull out firstly
the lower end of helical spring from lower
spring seat of rear tow arm and then screw out
the spring.
2. In assembly，you should let the upper end of rear
helical spring attach the limit face of upper
rubber mat of helical spring and then the lower
end of rear helical spring with the mounting
surfaces of tow arm，otherwise it will result in
abnormal noise during the driving process.
Removal/installation of rear cross-tie rod
Attention
Prior to carry out the following operations, if the wheel sensor is not removed at first from the ABS, it
will cause pull-out of wrong harness and result in harness breakage. Prior to carry out the following
operation, remove at first the speed sensor of wheels (axle side) and place it in a suitable location to
prevent from pulling out a wrong harness.
1 Remove in the order as shown in the Table;
2 Install in the reversing order of removal;
3 Check the alignment of rear wheels and make the adjustment as necessary.
Notice to the installation of rear tie rod
1. In assembly of 3 tie rods, note to tell apart the left from the right and the upper from the lower. The color
as identified from the view at the rear of vehicle is
S/C
Part name Color identification
1 Rear tie rod(left upper) Red
2 Rear tie rod(left lower) White
3 Rear tie rod(right upper)
Yellow
4 Rear tie rod(right lower)
Non
To Next Page
Loading...