Rear suspension
R-13
1 Nuts(connection of rear tie rod(Lower) with the rear tow arm)
2 Nuts(connection of rear tie rod(Upper) with the rear tow arm)
3 Bolt
4 Rear tie rod(Upper)
5 Rear tie rod(Lower)
Removal instructions of nut, cam disc and cam adjusting bolt
1. Prior to unscrew the cam nut, mark on the spacer and bodywork mounting bracket for reference during
the mounting process;
2. Use a lifter to jack up the rear axle and then loosen the mounting bolt;
3. Jack up the front end of tow arm and remove the mounting bolt, cam nut and eccentric sleeve;
Attention: The eccentric sleeve after removed cannot be reused. Thus do not remove eccentric sleeve if there
is no special.
Mark
To Next Page
Loading...