Alarm and Indication System
T-14
Check of combination instrument
Speedometer
Use of input/output inspection mode
Set the speedometer at the DTC 12 under the
input/output inspection mode and check the
speedometer.
Use of speed detector
1. Adjust the tire pressure to the specified value;
2. By use of the speed detector, confirm the
indication of speedometer is within the range
of the following table:
Indication of
speedometer (km/h)
Allowed range (km/h)
20 18-22
40 36-44
60 54-66
80 72-88
100 90-110
120 108-132
140 126-154
160 144-176
180 162-198
200 180-220
220 198-242
3. Verify that the fluctuation of speedometer
pointer remains within the allowed range. If the
speedometer pointer doesn’t move or the
indication is beyond the allowed range, check
the ABS hydraulic unit/control module and
relevant harness. If the ABS hydraulic
unit/control module and relevant harnesses are
normal, replace the combination instrument.
The tolerance of pointer fluctuation is in the
scope of 3.0 km/h.
Tachometer
Use of input/output inspection mode
Set the tachometer at the DTC13 under the
input/output inspection mode and check the
tachometer.
Use of static speed tester
Attention:
If the engine speed exceeded the allowed scope, it
will be damaged, thus, do not let the engine speed
be higher than the range as permitted by the
tachometer indication when checking the
tachometer.
1. Connect the static speed tester with the
IG-connector of DLC.
2. Verify that the pointer of static speed tester
remains within the allowed range shown as in
the following table. If the pointer of static
speed tester doesn’t move or the pointer
exceeds the allowed scope, check the power
system control module of engine speed signal
transmitter and relevant harness. If the power
system control module of engine speed signal
transmitter and relevant harness are in normal
state, replace the combination instrument.
Speed tester indication
(rpm)
Allowed scope (rpm)
1000 951-1077
2000 1976-2134
3000 3000-3190
4000 4024-4248
5000 5049-5305
6000 6073-6361
7000 7097-7418
8000 8121-8475
Fuel gauge
Set the fuel gauge at the DTC 23 under the
input/output inspection mode and check the fuel
gauge.
DLC (data transmission connector)
To Next Page
Loading...