Wiper and washer
T-12
Removal/installation of rear wiper arm
and blade
1. Remove in the order as shown in Fig.;
2. Install in reverse order with that of removal;
3. Adjust the rear wiper arm and blade (See the
Adjustment of Rear Wiper Arm and Blade)
1 Guard of rear wiper arm
2 Nut
3 Rear wiper arm
Rear wiper blade
Installation instructions of rear wiper arm
1. Prior to the installation, clean with the wire
brush the arm coupling shaft of rear wiper.
Adjustment of rear wiper arm and blade
1. Enable the rear wiper to operate so as to make
the wiper to stop at the Stop position.
2. Align the wiper arm with the mark.
Removal/installation of rear washer nozzle
1. Disconnect battery negative cable;
2. Remove the washer pipe plug;
3. Remove the connecting hose on the rear
washer nozzle;
4. Press the lock latch on the rear washer;
5. Detach the rear washer nozzle;
6. Install in reverse order with that of removal.
7. Adjust the direction of rear washer nozzle (See
the Adjustment of Rear Wiper Arm and Blade)
Connector at element side
(viewed from the terminal side
Switch
Mark
To Next Page
Loading...