RKE (Remote Control System)
T-61
RKE (Remote Control System)
Removal/installation of remote controller
1. Remove the negative cable of battery;
2. Disconnect the connector of remote controller;
3. Dismantle with a wrench the remote controller
and mounting bracket from the bodywork.
4. The installation procedure is in reverse order
with that of the removal.
Check of remote controller
1. In case, where the door or trunk lock cannot be
unlocked, or door lock light cannot be turn off
by remote control in normal use, it means that
there is a fault in the remote center control
transmitter or the host.
2. Confirm whether the battery of remote central
control transmitter needs to replace. The
replacement procedure is referred to in the
product instruction manual.
3. If the problem persists after the remote central
control transmitter replaced, confirm whether
the harness is in sound connection, the
actuating device of door or trunk lock is
normally operating and the door lock relay
intact.
4. If everything is in order after the above check,
it means that there is a fault in the remote
controller, and the remote controller shall be
replaced.
Reversing radar system
Removal/installation of reversing radar
host
1. Remove the negative cable of battery;
2. Disconnect the connector of reversing radar
host;
3. Dismount with a wrench the reversing radar
host and mounting bracket from the bodywork.
4. The installation procedure is in reverse order
with that of removal.
Check of reversing radar host
1. When there are wrong alarms in normal use of
reversing radar system, it means there is a fault
in the reversing radar sensor or host
2. Confirm whether the harness connecting the
reversing radar system is intact.
3. Check whether the reversing radar sensor has
any problems. The check method is shown as
below:
1) Shut down, and check whether there are any
foreign matters on the surface of reversing
radar sensor.
2) Set the ignition switch on the ON position.
3) Place the shift mechanism on the reverse
position.
4) Record the following beep mode of buzzer; If
the reversing radar sensor just “beeps” once, it
means there is no faults in the reversing radar
sensor, if it sounds twice like “BI”“BI”!, it
means there is problem in one of the reversing
radar host bracket
connector
Mounting screw
RKE host
radar host
radar host bracket
Harness joint
Mounting screw
RKE host
radar host
To Next Page
Loading...