Wiper and washer
T-9
Removal/installation of windshield wiper
arm and wiper blade
1. Remove as per the order indicated in the Table;
2. The installation procedure is in reverse order
with that of removal;
3. Adjust the windshield wiper arm and wiper
blade; (See the Adjustment of Windshield
Wiper Arm and Wiper Blade)
1 Cover
2 Nut
3 Windshield wiper arm
4 Windshield wiper blade
Essentials to installation of windshield
wiper arm
Prior to installing the windshield wiper arm and
clean, with a brush the coupling shaft of windshield
wiper arm;
Adjustment of windshield wiper arm and
wiper blade
1. Start up the motor of windshield wiper and
make the wiper stop at the initial position;
2. Adjust the windshield wiper arm as per the
method shown in the following Fig.
Removal/installation of the fluid reservoir
of washer
1. Disconnect battery negative cable;
2. Partly lift up the right fender;
3. Remove as per the order indicated in the Table;
4. The installation procedure is in reverse order
with that of the removal.
1 Snap
2 Harness connector
3 Front end of washer tube
4 Bolts (2 pcs)
Removal/installation of windshield washer
motor
1. Disconnect battery negative cable;
2. Partly lift up the right fender;
3. Remove washer fluid reservoir.
4. Remove as per the order indicated in the Table;
5. The installation procedure is in reverse order
with that of the removal;
coupling shaft
Mark
To Next Page
Loading...