Anti-lock brake system (ABS control unit)
P-29
Removal and installation of HU/CM of ABS control unit
Caution
● Do not let the ABS control unit drop down to the floor. If they are subject of an impact, then they shall be
replaced.
Attention
● The pressure unit of ABS control unit hydraulic is purchased as an integrated part with the control
modular of ABS control unit. If any one of two functions lost efficacy, the pressure unit of fault ABS
hydraulic or fault ABS control modular shall be replaced entirely instead of separately.
1. Remove the air filter assembly, battery and intake hose.
2. Remove as per the order as shown in the Table.
3. Install in the reversing order of removal.
1 Harness connector 8 Nut
2
Driven cavity tubing of brake master
cylinder
9 Nut
3
Drive cavity tubing of brake master
cylinder
10 ABS control unit modular
4 Right front brake lines assembly 11 Locking bolt
5 Left front brake lines 12 Locking bolt
6 Front end of left right brake line 13 Locking bolt
7 Front end of right rear brake line 14 ABS control unit holder
To Next Page
Loading...