Lubrication system
38
Assembly instructions of oil filter
1. Install the oil filter spacer as shown in the left diagram.
2. Tighten the bolts as per the order shown in the right Fig.
Break down/installation of oil pump and timing sprocket casing
1. Remove the timing sprocket casing (See——Removal/installation of Timing Sprocket
Casing).
2. Break down as shown in the following Fig.
3. Assemble as per the reversing order of the disassembly.
1 Oil pump cover
2 External rotor
3 Internal rotor
4 Pressure spring
5 Control piston
6 Timing sprocket casing
Rotor clearance inspection
1. Measure the following clearance, and replace rotor and/or pump body if necessary.
Standard tip clearance: 0.06～0.18 mm{0.0024～0.0070in}
Max.tip clearance: 0.22mm {0.009in}
Inside the oil pan
Check of oil pump
Check of oil pump
To Next Page
Loading...