Wiper and washer
T-8
Wiper and washer
Removal/installation of windshield wiper
motor
1. Disconnect battery negative cable;
2. Remove the wiper arm and wiper blade (See
the Removal/Installation of Windshield Wiper
Arm and Wiper Blade).
3. Remove the front wall grille (See the
Removal/Installation of Front Wall Grille);
4. Remove as per the order indicated in the Table;
5. The installation procedure is in reverse order
with that of removal;
6. Adjust the wiper arm and wiper blade (See
Adjustment of Windshield Wiper Arm and
Wiper Blade).
1 Harness connector
2 Bolt
3 Wiper motor
Disassembly/assembly of windshield wiper
motor
1. Disassemble as per the order indicated in the
Table.
2. The assembly procedure is in reverse order of
that of disassembly.
1 Nut
2 Bolt
3 Windshield wiper linkage
Check of windshield wiper motor
1. Disconnect the connector of windshield wiper
motor;
2. Connect the positive voltage of battery with the
terminal D or F and check the operation of
windshield wiper motor as indicated in the
following table.
Terminal Work condition
F High speed
D Low speed
3. When the wiper is operating, remove the
positive connector of battery from the motor
terminal E;
4. Assure the continuous operation of wiper when
it is in the Stop position.
5. Short-circuit the motor terminal E and C and
connect the positive voltage of battery with the
motor terminal E;
6. Confirm that the wiper is operating at low
speed and stops at the Stop position. Replace
the motor of windshield wiper when it is
non-conforming to the technique requirements.
Joint of part (viewed from the
connection terminal side)
Auto-Off Switch
To Next Page
Loading...