Rear suspension
R-11
Rear suspension
Removal/installation of rear shock absorber
Attention:
Carry out the following procedures prior to the
removal of ABS wheel speed sensor. If the
sensor pulled by inadvertence，it may result in
break-circuit of harness. Before carrying out the
following procedure, remove the ABS wheel
sensor (at the axle side) corresponding to the
axle and fix it in a suitable position, at the
meantime, remove the snap plate fastening the
fixing hose and make it movable to prevent the
wheel sensor from inadvertent drawing during
the maintenance process. In use of a lifter, pay
attention not to damage the braking tube and
hose.
1. Remove in the order as shown in the Table;
2. Install in the reversing order of removal.
1
Nut
2
Bolt
3
Flange nut of rear shock absorber
4
Amounting nut of rear shock absorber
5
Fixing spacer
6
Upper rubber sleeve
7
Lower rubber sleeve
8
Rear shock absorber.
Check of rear shock absorber
1. Check the rear shock absorber by the same method as Check of Front Shock Absorber. (See
R-12——Check of Front Shock Absorber)
Scrap Disposal of rear shock absorber
1. Check the rear shock absorber by the same method as Check of Front Shock Absorber. (See
R-12——Check of Front Shock Absorber)
To Next Page
Loading...