Control system
U-13
4. install in reverse order as of removal.
1 A/c relay
A/c relay inspection
1. remove a/c relay.
2. inspect continuity between the a/c relay
terminals with an ohmmeter. If it is not as
specified, replace a/c relay.
Blower relay removal/ installation
1. disconnect the negative battery cable.
2. remove passenger side panel.
3. install in reverse order as of removal.
1 Connector
2 Front blower relay
Blower relay inspection
1. remove the bracket.
2. inspect continuity between the blower relay
terminals with an ohmmeter. If it is not as
specified, replace the blower relay.
Continuity
Step
Terminal
Connector of component
(view from terminal)
Continuity
Terminal
Step
Connector of component
(view from terminal)
To Next Page
Loading...