HAIMA 7 - Assembly Instructions of Oil Pan; Removal;Installation of Oil Pan Body; Disassembly Instructions of Oil Pan Body; Assembly Instructions of Oil Pan Body

Lubrication system
35
Assembly instructions of oil pan
Caution
l If the bolt is reused, the sealant on
the old thread has to be removed.
The screw with old thread sealant
may damage the screw hole.
1. Add continuously sealant around the
inside of oil pan bolt hole and make the
end overlapped.
Sealant diameter: Φ2.0～
Φ3.0mm{0.079～0.118in}
2. Install the oil pan.
Removal/installation of oil pan body
Disassembly instructions of oil pan body
1. Remove two bolts behind the oil pan body.
2. Unscrew, in 2—3 steps, the oil pan body bolts as per the order shown in Fig.,below.
3. Use the split tool to remove the oil pan body.
Assembly instructions of oil pan body
1. Smear evenly the sealant on the oil pan
body as shown in the following Fig.
Sealant diameter: Φ2.0～Φ3.0mm{0.08～
0.11in}
2. Tightening bolt A.
Tighten the oil pan body bolts in 2-3 steps
as per the reversing order of the
disassembly (See—— Disassembly Oil
Pan Body)
Fissure
Old sealant
Oil pan
Sealant smeared
prior
to the installation
Split tool
Bolt
Sealant smeared prior to the installation
Sealant smeared prior to the installation