Parking Brake System
P-18
Removal and installation of rear parking brake
1. Disassemble in the order as shown in the Table.
2. Assemble in the reversing order of disassembly.
3. After installation, adjust the brake shoe clearance and carry out the following jobs.
(1) Step the brake pedal several times and then confirm that no brake blocking exists
(2) Check the clearance between the pedal and floor.
(3) Check the travel of parking brake handle.
1 Rear brake disc
6 Parking adjustment mechanism
2 Clamping pin 7 Parking brake shoe assembly
3 Brake shoe support spring 8 Rear parking cable
4 Upper return spring 9 Push plate and brake plate assembly
5 Lower return spring 10 Rear mudguard
To Next Page
Loading...