Steering system
N-6
● Confirm that the steering shaft is loosened
when the adjusting rod is locked.
Removal/installation of steering and
connecting rod
Caution
● Carry out the following operations, if the wheel
speed sensor in the ABS system is not going to
be removed first. When the wrong harness is
pulled, it will result in the break-circuit of
harness. Thus, prior to carry out the following
operation, remove the wheel speed sensor (at
the side of axle) and place it at a suitable place,
the wrong drawing of harness may be avoided.
1. Remove in the order as shown in the Table.
2. Install in the reversing order of removal.
3. After installation, check the toe-in of wheels
(Refer to the Positioning Parameters of Wheels,
Positioning Parameters of Front Wheels).
1
Bolt (intermediate shaft ): Refer to the Disassembly Instructions /
Refer to the Installation instructions
2 Cotter pin
3 Flange nut
4
Steering tie rod end ball:
Refer to the Disassembly Instructions;
Refer to the Disassembly Instructions
5 Hollow bolt
6 Oil return tube
7 Steering fixing bolt
8 oil pipe
9
Steering pinion and torsion rod:
Refer to the Disassembly Instructions
Locking
Adjusting rod
Unlocking
To Next Page
Loading...