Wiper and washer
T-15
Water temperature gauge
Set the water temperature gauge at the DTC 24
under the input/output inspection mode and check
the water temperature gauge.
Repair of combination instrument
Attention
When the pointers of speedometer and engine
tachometer will possibly jitter back and forth and is
unable to indicate correctly the speed or revolution
during the normal operation, please check as per the
following procedures:
1. Identify the failure.
2. Confirm that the ROOM fuse has been
installed;
3. Start up the engine and let the engine speed
achieve 5,500rpm or until the pointer does not
appear vibrated for a long time
(counterclockwise).
4. Lower the engine speed down to idle and set
the ignition switch on the LOCK position, and
then turn the ignition switch to the ON
position.
5. Confirm the pointer is reset to zero.
6. If the above procedures cannot reset the pointer
to zero, remove the gauge cover and carefully
calibrate the pointer with hand.
7. Note that it is a normal instead of a failure that
the pointer vibrates when the battery is charged
for the first time or the ROOM fuse replaced.
Check of fuel gauge sensor
1. Remove fuel gauge sensor.
2. Let the float move between the apogee and
perigee, measure with an ohmmeter and
confirm the resistance of fuel gauge sensor unit
between the terminals A and B.
3. Confirm the the apogee and perigee of float
position as shown in Fig., replace the fuel
gauge sensor if it fails to meet the technique
requirements.
Measuring
point
E
Red
wire
1/4 1/2 3/4 F
Volume 3L 9L 15L 30L 45L
55L
Resistance
240±6
215±6
190±5
140±4
90±3
40±2
Pointing to zero
Measure point
To Next Page
Loading...