Wiper and washer
T-13
Adjustment of rear washer nozzle
Insert a needle or similar tool into the spray orifice
on the rear washer nozzle and adjust the direction of
spray orifice.
Removal/installation of rear washer hose
1. Disconnect battery negative cable;
2. Remove necessary trim panel above the right
side wall;
3. Remove the washer hose from the clamp;
4. Partly lift up the right fender and remove the
hose from the clamp;
5. Remove the hose from the washer tank;
6. Install in reverse order with that of removal.
Lock latch
Snap
Washer hose
Washer tank
To Next Page
Loading...