HAIMA 7 - Driver-Sided Safety Airbag Module

Safety airbag system
T-55
5. Connect the red clamp of special release tool
with battery positive terminal, and the black
clamp with battery negative terminal.
6. Confirm that the red light on the special release
tool is lit.
7. Be sure that all staff stay at least 5m {20ft}
away from the vehicle.
8. Press the trigger switch on the special release
tool to release the occupant--sided safety airbag
module.
Pretensioning safety belt
1. Remove the lower interior trim panel of the
column B
2. As shown in Fig., remove the pretensioning
safety belt and connect the switch harness of
special tool with the pretensioning safety belt.
3. Install the pretensioning safety belt.
4. Connect the special release tool with the switch
harness of special tool.
5. Connect the red clamp of special release tool
with battery positive terminal, and the black
clamp with battery negative terminal.
6. Confirm that the red light on the special release
tool is lit.
7. Be sure that all staff stay at least 5m {20ft}
away from the vehicle.
8. Press the trigger switch on the special release
tool to release the pretensioning safety belt.
Release procedure outside vehicle
1. Check the special release tool.
2. Turn the ignition switch to the LOCK position.
3. Remove the negative cable of battery and wait
for more than 1min.
4. Release as per the suitable procedure the
driver-sided safety airbag module,
occupant–sided safety airbag module or
pretensioning safety belt.
Driver-sided safety airbag module
1. Remove the driver-sided safety airbag module;
2. Install the bolts on the driver-sided safety
airbag module.
Trigger
switch
Pretensioning safety
belt
Trigger
switch