Power supply system
T-8
3 Bulb 12V5W (W5W)
4 Bulb 12V5W (W5W)
5 Reading light holder
Note: The installation structure of reading light on
the ceiling and the replacement of bulb may refer to
the above procedure for maintenance.
Removal/installation of indoor light and
bulb
1. Remove the negative cable of battery;
2. Take out the lens.
3. Take out two screws by use of a cross
screwdriver;
4. Take out the indoor light from the holder;
5. Disconnect connector;
6. The installation procedure is in reverse order
with that of the removal.
Note: When replacing the bulb, just remove the lens
to take out the bulb and replace it.
1 Lens
2 Bulb
3
Bulb 2V 5W (W5W)
4
5
Self-tapping screw HQ99865-0516
(Installation torque: not more than 5.9)
6
Removal/installation of trunk lamp and
bulb
1. Remove the negative cable of battery;
2. Press down one end of the snap with a small
screwdriver through the small hole, so as to
enable the snap come off the ceiling and
obliquely take out the fixture;
3. Disconnect connector;
4. When installing, fit first, the left end of fixture
into the roof and then the right end
Note: The bulb can be removed after the lamp taken
out.
1 Bulb
2 Reading light
Removal/installation of the lighting bulb of
ignition switch
1. Disconnect battery negative cable;
2. Remove the steering column cover;
3. Take out the ignition switch lighting lamp
bulb.
4. The installation procedure is in reverse order
with that of the removal
Snap
lighting bulb
To Next Page
Loading...