Safety airbag system
T-59
Released safety airbag module and
pretensioning safety belt
After the safety airbag module and pretensioning
safety belt just released, the high temperature may
result in scald. Do not touch relevant parts within
15mins after the safety airbag module and
pretensioning safety belt released.
It is dangerous to water the released safety airbag
module and pretensioning safety belt. The
combination of water with residual air will produce
gas hard to breathe. Hence, do not water the
released safety airbag module and pretensioning
safety belt.
The released safety airbag module and pretensioning
safety belt may contain the sodium hydroxide
precipitate, a corrosive byproduct produced from
gas combustion. If this substance gets into eyes or in
contact with the hands, it can cause discomfort and
itching. When handling with a released safety airbag
module and pretensioning safety belt, you should
2. Wear the gloves and safety goggles.
Place the safety airbag module and
pretensioning safety belt into a plastic bag. Seal
up the plastic bag and then have it disposed
3. Take off the gloves and wash hands.
Check of special release tool
Prior to handling the safety airbag module and
pretensioning safety belt not yet released under
working state, use a special release tool to release
them. Before use of a special release tool, check its
work condition.
Checking procedure
Check and confirm that the special release tool
operates properly as per the following steps. If it
fails to meet the technique requirements, do not use
the special release tool, because, it may result in
sudden releases of the safety airbag module and
pretensioning safety belt, if it is connected with the
safety airbag module or pretensioning safety belt.
Steps Check procedures
State of
indicator light
Green
Red
1
Connect the red clamp
with battery positive
terminal and the black
clamp with the battery
negative terminal
Lit Unlit
2
Connect the connector
A of special release
tool with the connector
B.
Unlit Lit
3 Press the trigger switch
Lit unlit
Trigger
switch
Clamp
Connector A
Connector B
Green light
Trigger switch
Red light
Red clamp
Black clamp
To Next Page
Loading...