Switch and relay
T-73
3. Disconnect the connector of rear fog lamp
relay;
4. Pry up with a flathead screwdriver, the upper
side of lock part. Remove the relay rear fog
lamp relay.
5. The installation procedure is in reverse order
with that of removal.
Check of rear fog lamp relay
1. Remove the bracket and draw toward yourself;
2. Check the continuity between all terminals of
rear fog lamp relay with an ohmmeter. If it fails
to meet the technique requirements; replace the
relay of rear fog lamp relay.
Relay circuit diagram
Element side connector (viewed from the terminal
side)
Part of alarm system
Removal/installation of horn
1. Remove the negative cable of battery;
2. Remove the front bumper;
3. Disconnect the connector of horn;
4. Remove the bolts
5. Remove the horn;
6. The installation procedure is in reverse order
with that of the removal.
1 Screw HQ99786-0616 (torque: 7.2～12N.M)
2 Bodywork
3 Horn
Removal/installation of horn relay
1. Remove the negative cable of battery;
2. Remove the cover of main fuse box;
3. Remove in the order as indicated in the Table;
4. The installation procedure is in reverse order
with that of the removal.
1 Horn relay
Bracket
relay
Connector
lamp relay
Continuity
Connection terminal
Steps
Grounding
Main fuse box cover
To Next Page
Loading...