Rear suspension
R-14
Removal/installation instructions of rear frame plaque
1. Remove in the order as shown in the Table.
2. Install in the reversing order of removal.
1
43～68
{4.3～6.9,31.8～50.3}
2
1 Bolt
2 Rear frame plaque
Removal/installation instruction of rear beam
1. Remove the tie rod of upper/lower rear beams(Refer to the Removal/Installation Instructions of Rear
Suspension and Tie Rod);
2. Remove the rear frame plaque(Refer to the Removal/Installation Instructions of Rear Frame Plaque);
3. Remove the rear frame;
4. Install in the reversing order of removal;
5. Check the rear wheel alignment. Adjust it if necessary.
To Next Page
Loading...