Switch and relay
T-67
3. Compress by hands the upper/lower snaps on
the switch behind the dashboard until the
switch is able to pass through the mounting
hole;
4. Take out the switch;
5. The installation procedure is in reverse order
with that of the removal.
1 Front/rear fog lamp switch
2 Dashboard
Check of front/rear fog lamp switch
1. Remove the switches of front/rear fog lamp.
2. Test by use of a multimeter, the continuity
between the switch terminals according to the
diagram. If it fails to meet the technique
requirements, replace the switch.
Removal and installation of rheostat
1. Disconnect battery negative cable;
2. Remove the side panel of dashboard;
3. Compress by hands the upper/lower snaps on
the switch behind the dashboard until the
switch is able to pass through the mounting
hole;
4. Take out the switch;
5. The installation procedure is in reverse order
with that of the removal.
1 Rheostat
2 Dashboard
Check of rheostat
1. Remove the rheostat;
2. Test by use of a multimeter, the continuity
between the rheostat terminals according to the
diagram. If it fails to meet the technique
requirements, Replace rheostat.
Snaps of upper/lower ends
lamp switch
switch
Backlight
Front/rear fog lamp switches diagram
Definition of the front/rear fog
Snaps of upper/lower ends
To Next Page
Loading...