How to use this manual
GI-3
Symbols
There are 8 symbols to represent the uses of
lubricant, grease and sealant and special tools. These
symbols stand for the application of the above-said
materials during the maintenance.
Symbols Meaning Remark
Add the lubricant Add new engine or
gear oil
Add the brake
liquid
Use only the brake
liquid
Add the
auto-transmission
liquid
Add new
auto-transmission
oil
Add the grease Appropriate grease
Add the sealant Appropriate sealant
Add the Vaseline Appropriate
Vaseline
Part replacement O-seal ring, spacer
etc.
Use of special
tools
Suitable special
tools or equipment
Hint signal:
You will read, in this manual, warning, caution,
attention, statement and upper/lower limits;
Warning:
The overlook of warning notice will result in
personnel injury.
Caution:
Be careful of vehicle damage caused by negligence.
Attention:
Pay attention to additional information necessary for
the completion of some procedures.
Statement:
Prompt the range allowed by the check or adjustment.
Upper/lower limits:
Prompt the upper/lower limits which cannot be
exceeded by check or adjustment.
Fault diagnostic procedure
Basic diagnostic flow:
On-board diagnostics
Ÿ The fault codes are the important clues of fault
repair. The fault diagnostics may be quickly
executed according to the listed fault codes.
When the fault codes are in display, the cause of
fault is identified. Afterward, the inspection is
carried out according to the indication of
diagnostic.
Engine adjustment (Part F)
Ÿ All adjustments must be carried out after the
engine started.
Basic inspection (Part K)
The basic check is intended to quickly exclude the
unrelated fault reasons to lessen the fault scope while
determining the failure part for the fault exclusion.
Diagnostic index
Ÿ The diagnostic index lists out the symptoms of
faults, according to which, the suitable or similar
system and methods are searched for inspection.
Fast diagnostic diagram (if related)
Ÿ The fast diagnostic diagram lists out the
diagnostic items and relevant inspection process.
Symptom diagnostics
According to the diagnostic steps of symptoms,
quickly determine the cause and location of failure.
On-board diagnostic
Engine diagnostic
Actual overhaul process
Basic check
Diagnostic index
Fast diagnostic diagram
Symptom diagnostic
System check
Only for Part F
Only for Part K
Only for Part F
Check of
diagnostic
If prompted
To Next Page
Loading...
