Switch and relay
T-70
3) Confirm other harnesses are properly
connected and the ignition key in the ON
position;
4) Observe whether there are pulses under AUTO
gear. If yes, it means that the main switch of
power window is damaged. Please replace the
main switch of power window;
5) If no pulses available, please confirm whether
the window regulator has the anti-trap function.
If it does, it means that the window regulator is
damaged, please carry out the maintenance in
reference to the window regulator maintenance
of accessory system.
5. If unable to properly close the windows (It
behaves in such manner that the window
bounces back automatically after raised to the
top, which hinders the window to close), please
check whether the PIN B shown in the above
Fig. is disconnected when raised to the top. If
yes, it means that the main switch of power
window was damaged. Please replace the main
switch of power window.
Installation/removal of auxiliary power
window
1. Remove the negative cable of battery;
2. Pry out the switch panel with a straight
screwdriver.
3. Disconnect the connector of power window
switch;
4. Remove the mounting screws by use of a
screwdriver;
5. The installation procedure is in reverse order
with that of removal.
1 Switch panel of aux. power window switch
2 Aux. power window
3
Self-tapping screw HQ99874-0412 (torque:
not more than 2.9 N.m)
4
Door assembly (incl. right front and rear
doors)
Installation/removal of front door switch
1. Remove the negative cable of battery;
2. Unscrew the fastening screws;
3. Undo the inner trim panel and pull out the plug.
4. Take out the switch;
5. The installation procedure is in reverse order
with that of removal.
1
Self-tapping bolt HQ9YA56-0601 (torque:
6.9～9.8 N.m)
2 Door switch
Note: the methods of installation/removal of front
doors are just same as those of back doors.
Test of door switch
1. When the backlight brightness of dashboard
cannot be properly adjusted, please check
according to the following steps.
2. Check whether the harness connecting the
rheostat is in sound connection, whether the
TNS relay in good performance, the small
switch turned on and properly operated.
3. If the problem persists, please remove the
rheostat and check whether the rheostat works
normally. If unable to work in a sound way, it
means that the rheostat is damaged, please
replace the door switch.
Front part
Rear part
grounding
grounding
To Next Page
Loading...