Power supply system
T-6
Attention: When removing the taillight, after
unscrewed the nuts 3 and 5, a certain tension is
required when the taillight is pulled out along the
axis X because there is the location pin sheath No.4,
which is used for fixing the location pin of taillight
Removal/installation of rear combined
lamp bulb
1. Remove rear combined lamps;
2. Unscrew counterclockwise with hand and pull
out the bulb holder of rear combined lamps;
3. Take out the bulb and replace it;
4. Install in the reverse order.
1
Turning lamp bulb12V21W(PY21W)
2
Turning lamp holder
3
Rear fog lamp/backup lamp bulb 12V16W
(W16W)
4
Rear fog lamp/backup lamp holder
5
Rear combined lamps
Note: the brake light and position light are LED
structured. When this part is damaged, it is
necessary to replace the whole rear combined lamps
at a designated maintenance point.
Removal/installation of high-positioned
brake light
1. Remove the negative cable of battery and then
the hole plug;
2. With hand or other tools, take out the fixture
while pressing down the support clamp of high
mounted brake light through bodywork hole.
3. Disconnect the connector; take out the fixture
and replace it.
4 Install in the reverse order.
1 High-positioned brake light
2 Hole cover
3 Hole cover
4 Hole cover
Note: the light source of the high-positioned brake
light is LED. Replace the whole lamp if the source
is damaged.
Removal/installation of license plate lamp
1. Disconnect the negative of power supply;
2. Remove the back door trim panel and then the
cover of license plate lamp.
3. Press out the snap of license plate lamp, with a
straight screwdriver, through the open-hole of
back door inner panel and push out the license
plate lamp;
3. Take out the license plate lamp (two lamps are
identical and in the same direction);
4. Pull out the connector at the harness end;
5. The installation is in reverse order, push
clipping
To Next Page
Loading...