HAIMA 7 - Flywheel and Clutch; Removal;Installation of Flywheel and Clutch; Disassembly Instructions of Clutch Compressing Disc and Disc Plate

Flywheel and clutch
61
Flywheel and clutch
Removal/installation of flywheel and clutch
1. If necessary to disassemble the crankshaft rear cover, the oil pan body shall be removed at
first (See——Lubrication System, Disassembly/Assembly of Oil Pan Body).
2. Disassemble as per the order shown in Fig.
3. Assemble in the reversing order of disassembly.
1
Clutch compressing disc (See——Disassembly Instructions /See——Assembly
instructions)
2 Clutch disc plate(See——Disassembly Instructions /See——Assembly instructions)
3 Flywheel (See——Disassembly Instructions /See——Assembly instructions)
4 Pilot bearing(See——Disassembly Instructions /See——Assembly instructions)
5
Crankshaft rear cover(See——Disassembly Instructions of Rear Oil Seal
/See——Assembly instructions of Rear Oil Seal /See——Assembly instructions)
6 Gearbox partition
Disassembly instructions of clutch compressing disc and disc plate
1. Use a special tool to lock the flywheel and localize the clutch (as shown in Fig.).
2. Unscrew the bolts by one time, as per the criss cross method, until the pressure of
diaphragm spring has been released.
3. Remove the clutch compressing disc and disc plate.
Smear prior to
the installation
Special tools for
disassembly and assembly
Part
replacement is
necessary after
removal
Part replacement is
necessary after removal
Sealant coating is
necessary after the
rear cover installation
Sealant coating is
necessary after the
rear cover installation
Sealant coating is necessary
after the rear cover installation
Sealant coating is necessary
after the rear cover installation