HAIMA 7 - Check of Engine

Generator and Starter
21
Deflection mm{in}
[The force of 98N{10kgf, 22lbf} shall be applied in-between]
New Old
Alternator
belt
6.5～7.5
{0.26～0.29}
7.0～9.0
{0.28～0.35}
Tension N{kgf, lbf}
New Old
Alternator
belt
686～834
{70～85,
160～180}
490～686
{50～70,
120～150}
3. Tighten the bolts A and B as per the torque shown in Table.
4. Check the deflection or tension of belt (See——Check of Engine Belt).
l If not within the standard value, readjust by starting from the 1
st
step and.
Check of engine
1. Confirm that the battery has been charged.
2. Confirm that the deflection/tension of belt is within the defined range (See——Generator,
Check of Engine Belt).
3. Set the ignition switch in the “ON” position, now the charge warning light is lit.
4. Confirm that the charge warning light goes off when the engine started operating.
l If not in such case, refer to CBU Faults Diagnostic and Disposal.
Engine
Measuring point
Water
pump
Crankshaft pulley
Belt pressure gauge
At the time of
measurement
At the time of
installation