Brake system
P-5
Service of brake switch
1. Disconnect the connection of brake switch plug.
2. Connect an ohmmeter between two terminals of
brake switch plug to check whether the circuit is
put through.
3. If inconsistent to the case as specified in the
table, replace the brake switch.
Disassembly/installation of brake master
cylinder
1. Remove in the order of 1-2-3-4-5-6-7-8.
2. Install in the reversing order of removal.
1
Liquid level sensor plug
2
Pipe clamp
3
Inlet hose of clutch master cylinder
4
Front cavity pipe of brake master cylinder
5
Rear cavity pipe of brake master cylinder
6
Flange nut
7
Flange nut
8
Brake master cylinder
Circuit put through
Terminal
Conditions
When the brake is stepped down
When the brake is not stepped down
To Next Page
Loading...