Cylinder head and valve mechanisms
48
Removal/installation of valve gear
1. Remove the cylinder head (SeeāāDisassembly of Cylinder Head).
2. Disassemble as per the order shown in the Fig.
3. Assemble in the reversing order of disassembly.
1
Valve split collet (please refer to the
Removal/Installation Instruction)
2 Upper seat of valve spring
3
Lower seat of valve spring (refer to the
Assembly Instructions)
4 Lower seat of valve spring
5 Valve
6
Valve oil seal(refer to
Removal/installation Instruction)
Disassembly of valve split collets
Use a special tool to press the lower seat of valve spring and remove the valve split collet.
Special tool designated to the
disassembly and assembly
Special tool designated to the
disassembly and assembly
Part replacement is necessary after
the disassembly
Smear prior to the
installation
Valve spring puller
Pivot
To Next Page
Loading...