Flywheel and clutch
63
replacement.
Remove the oil seal by use of a screwdriver wrapped with protective cloth.
Assembly instructions of rear oil seal
1. Add clean oil on the oil seal.
2. Fit the oil seal with hands.
3. Use a special tool and hammer to press in the seal.
Press depth: 0～0.5mm{0～0.019in}
Assembly instructions of crankshaft rear cover
1. As shown in Fig., smear evenly the sealant in the groove of crankshaft rear cover.
Sealant diameter: Φ1.5～2.5mm{0.06～0.10in}
2. Fit the crankshaft rear cover.
Assembly instructions of flywheel
1. Fit the flywheel on the crankshaft.
Hammer
Rear cover
Rear oil seal
Dustproof cover installer
Sealant coating
To Next Page
Loading...