HAIMA 7 - Removal;Installation of Middle Switch; Maintenance of Middle Switch; Removal;Installation of Front;Rear Fog Lamp Switch

Switch and relay
T-66
Switch circuit diagram
Element side connector
Steering switch
Element side connector
Removal/installation of middle switch
1. Disconnect battery negative cable;
2. Remove the auxiliary fascia console;
3. Pry, with a screwdriver, three clamps on the
middle switch and auxiliary fascia console;
4. Take out the switch from the mounting hole
below.
5. Disconnect the switch connector of hazard
warning light. Remove the hazard warning
light switch.
6. The method of installation is in reverse order
with that of removal.
1
Middle switch (incl. hazard warning light
switch and door lock switch)
2 Auxiliary fascia console
Maintenance of middle switch
1. Remove the switch;
2. Check by use of a multimeter, the continuity
between the switch terminals according to the
diagram. If it fails to meet the technique
requirements, replace the switch.
Removal/installation of front/rear fog lamp
switch
1. Disconnect battery negative cable;
2. Remove the side panel of dashboard;
Flashing
by
Headlamp
High
Low
Off
Continuity
Switch position
Terminal
L
Off
R
L
R
Back
light
Back
light
Back
light
Central control
lock (locked)
Hazard
warning light
Central control
door lock
(unlocked)
Middle switch diagram
Middle switch terminal definition