Installation of radio system
Installation of radio system
If a radio system is not properly installed or a radio
set of large power used，CIS or other systems will be
affected.
When a radio system is going to be installed on a
vehicle，the following precautions shall be taken:
1. The position, where the antenna is used, has to
be away as far as possible from the control
module.
2. In installation of the antenna holder，try to keep
it away as much as possible from the control
module harness and perpendicular to the
harness.
3. Do not install the radio system of large power
4. After the radio system installed，start the engine
and run it idle to confirm whether the engine is
under the effect of waveband.
Electric system
Electric parts
Battery cable
When the connection is disconnected or an electric
parts removed，the negative cable of battery shall be
firstly disconnected.
Harness
Remove the harness from the clamp in the engine
room and pry up the clamp snaps with a straight
screwdriver.
Plug
Plug of data connection wire
When connection a jumper with a data plug，a
detector shall be inserted into the measuring hole
Caution:
When inserting a jumper detector into the data
plug，the terminal will be likely damaged.
To Next Page
Loading...