Lubrication system
40
Check of pressure spring
Apply pressure on the spring and check the
spring height. Replace the pressure
spring if necessary.
Pressure:
82.6～90.4N{8.43～9.22kgf, 18.56～
20.31lbf}
Standard height:
35.15mm [1.3839in]
Cold system
Removal/installation of thermostat
1. Disassemble as per the order shown in
Fig.
2. Assemble in the reversing order of
disassembly.
1 Thermostat cover
2
Thermostat
See——Precautions to Installation
Assembly instructions of thermostat
1. As shown in Fig., confirm whether the notches on the thermostat switching section and
thermostat washer have been aligned.
2. Align with the notch on the washer, and fit the thermostat on the thermostat switching
section.
Check of thermostat
Put the thermostat into a vessel containing hot water and then heat it up by inserting the
Bulge
Mobile pin
To Next Page
Loading...