Safety airbag system
T-62
radar sensors, if three beeps like “BI”“BI”“BI”,
it means there may be faults in two or more
reversing radar.
5) If there is a fault in the reversing radar sensor,
please replace the fault reversing radar sensor.
4. If everything is in order after check mentioned
as above, it means there are faults in the remote
controller and need to replace the remote
controller.
Removal/installation of reversing radar
sensor
1. Remove battery negative cable;
2. Disconnect the connector of reversing radar
sensor.
3. Remove the snap spring.
4. Pull out the reversing radar sensor from the
mounting hole of rear bumper.
5. The installation procedure is in reverse order
with that of removal.
Rear bumper
Reversing radar sensor
Snap spring
To Next Page
Loading...