Steering system
N-10
Decomposition description of inner guide
sleeve and oil seal
1. Install the special tool onto the valve side;
2. Install the special tool in the gear chamber.
3. Extrude the oil seal and inner guide sleeve.
Disassembly Instructions of rubber
cushion block
● Use a special tool and a presser to extrude the
rubber pad from the steering casing body.
Decomposition description of steering tie
rod ball dust cover
1. Place the end of tie rod on a jig and clamp it.
2. Clamp the end of tie rod as per the angle shown
in Fig. and use a chisel to align with the dust
cover.
3. Hit with a hammer, the chisel to remove the
dust cover.
Check of Steering and joint
Check of gear rack
1. Check the gear rack for any fracture, damage
and broken teeth.
● If yes, replace the gear rack.
2. Measure the radial run-out of gear rack. If it is
not within the specified range, replace the gear
rack.
Range of radial run-out
Near the point A: 0.15mm{0.006in}
Near the point B: 0.20mm{0.008in}
Check of steering tie rod ball
1. Check whether the end ball of tie rod is
damaged and the dust cover broken. Replace
when necessary.
2. Check whether the end ball is loosened.
Replace the tie rod end ball when necessary.
3. Turn the end ball 5 times.
4. Use a special tool and spring balance to
measure the rotation torque of end ball.
● If it is not within the specified range, replace
the tie rod end ball.
To Next Page
Loading...