Lighting system
T-7
directly, by hand the lamp toward the mounting
hole instead of using a screwdriver.
1 Back door
2 License plate lamp cover
3 License plate lamp
4 License plate lamp
Removal/installation of license plate lamp
bulb
1. Rotate counterclockwise with hand the lamp
holder to the opening position and take it out;
2. Pull out the bulb and replace it;
3. Install in the reverse order.
1 License plate lamp cover
2 Bulb 2V5W (W5W)
3 Bulb holder
Removal/installation of reading light
1. Remove the negative cable of battery;
2. Open the flip of glasses case.
3. Take out two screws with a cross screwdriver.
4. Take out the indoor light from the ceiling;
5. Disconnect connector.
6. The installation procedure is in reverse order
with that of the removal.
1
Self-tapping screw HQ99865-0520B
(torque: not more than 5.9 N·m)
2
3 Reading light holder
4 Glasses case flip
Removal/installation of reading light bulb
1. Remove reading light;
2. Pry with a straight screwdriver the lens of
reading light;
3. Take out the bulb and replace;
4. Install in the reverse order. Install the lens by
holding it pressed and clamped.
1 Lens (R)
2 Lens (L)
along the arrow
direction and push
outward
To Next Page
Loading...