HAIMA 7 - VVT Disassembly Instructions of Intake and Exhaust; Disassembly Instructions of Camshaft

Cylinder head and valve mechanisms
44
VVT Disassembly instructions of intake and exhaust
1. As shown in Fig. Disassemble by jamming the hexagonal casting on the camshaft with a
wrench
2. Remove the VVT fixing bolt.
3. Slight swing the VVT and carefully take it out from the camshaft.
Disassembly instructions of camshaft
1. Check and adjust the valve clearance when necessary (See this section, Valve
Clearance).
2. Check the end gap of camshaft (See this section, Check of spring).
3. Check the journal gap of camshaft (See this section, Check of spring).
4. Unscrew the camshaft bearing bolt, in 2–3 steps, as per the order shown in Fig.
VVT fixing bolt