Ignition and control systems
26
Removal/installation instructions of water temperature sensor
Use a special tool to disassemble/assemble the water temperature sensor.
Check of crankshaft position sensor
Check of clearance
Attention
l Do the following checks only when necessary.
1. Confirm that the crankshaft speed sensor has been correctly installed.
2. Use a feeler to measure the clearance between the platform of signal wheel protrusion and
crankshaft speed sensor.
l If in wrong clearance, you may adjust the crankshaft speed sensor or check for
any distortion and notch in the signal wheel protrusion(If yes, you should
replace the crankshaft pulley. See Timing Sprocket——Disassembly
Instructions of Crankshaft Pulley).
Standard value
0.5～1.1mm(0.020～0.043in)
Special sleeve
Clearance
Crankshaft speed sensor
Crankshaft pulley
Protrusion
platform
To Next Page
Loading...