Steering system
N-5
Disassembly instructions of steering wheel
Caution
● When removing the steering wheel, do not
use the hammer to hit the steering shaft, for
this will result in steering column.
1. Park your vehicle while orienting the wheels to
the front.
2. Use a suitable puller to remove the steering
wheel.
Disassembly Instructions of Steering
Lock Bolt and Bracket
1. Use a hammer and chisel to cut a slot on the
lock bolt.
2. Use a straight screwdriver to remove the bolt.
3. Decompose the steering lock component.
Disassembly instructions of full-lock
component
Caution
● When replacing the full-lock component, the
anti-theft bolt has to be changed either.
1. Turn the ignition key in the “`ACC” position.
2. Pull out the full-lock component.
Installation instructions of steering lock bolt and
bracket the
1. Install the steering lock component on the
steering shaft.
2. Confirm that the locking operation is correct.
3. Fit up the steering lock bolt.
4. Tighten the bolt until the bolt head comes off.
Installation instructions of steering shaft
Caution
Do not use the shaft to knock the steering shaft.
1. Tighten the bolt A.
2. Tighten the bolt B from the right side.
3. Screw in the bolt D after the bolt C has been
tightened.
Installation instructions of steering wheel
1. Adjust the clock spring (Refer to the
Adjustment of Clock Spring of Safety Airbag
System)
2. Orient the wheels to the front and install the
steering wheel.
Check of steering column
Carry out the check as below. Replace the
components of steering shaft as necessary.
1. Whether the steering column bearing is
damaged.
2. Length of steering shaft: 834-836 mm
{32.8-32.9in}
2. Tilting operation
● Confirm that the adjusting rod is able to move
from the non-lock position steadily to the lock
position.
To Next Page
Loading...