Lighting system
T-5
1 Turn signal lamp bulb12V 21W(PY21W)
2 High-beam bulb 12V 55W(H7)
3 Waterproof cover
4 Waterproof cover
5 Low-beam bulb 12V 55W(H7)
6 Position lamp bulb 12V 5W(W5W)
Removal/installation of front fog lamps
1. Remove the negative cable of battery;
2. Remove front bumper;
3. Pull out the harness connector;
4. Loosen three fastening screws.
5. Take out the front fog lamps;
6. Install as per the order in reverse with that of
removal.
1
Self-tapping screw HQ9CF60-0516B
(3.9～5.9 N·m)
2
3
4 Front fog lamps
Removal/installation of front fog lamp
bulb
1. Remove front fog lamps;
2. Rotate counterclockwise the bulb holder;
3. Take out the bulb (bulb integrated with the
bulb holder);
4. The installation procedure is in reverse order
with that of the removal.
1 Front fog lamp bulb12V 35W(H8)
2 Front fog lamp
Removal/installation of rear combined
lamps
1. Disconnect battery negative cable;
2. Remove the trunk trim panel;
3. Pull out the plug at the end of taillight harness
4. Loosen two nuts (No.3 and 5 as shown in Fig).
Pull out the taillight along the axis X
5. Pull out the sealing plug on the fixtures harness.
Take out the fixtures.
6. The installation procedure is in reverse order
with that of removal.
1 Rear combined lamps
2 Plastic snap
3
Nut HQ99940-0503 (4.5～7.0 N·m)
4 Location pin sheath
5
nutHQ99940-0503 (4.5～7.0 N·m)
To Next Page
Loading...