Front suspension
R-9
Removal/installation of front stabilizer bar
1. Remove the front beam assembly;
2. Remove in the order as shown in the Table;
3. Install in the reversing order of removal.
1 Control connecting rod;
2
Fixing plate of stabilizer bar: Refer to the
Installation Instructions of Fixing Plate of
Stabilizer Bar and Rubber Sleeve;
3 Rubber sleeve of stabilizer bar;
4 Front stabilizer bar.
Installation instructions of fixing plate of stabilizer
bar and rubber sleeve
1. Smear the rubber grease on the inner surface of
stabilizer bar sleeve;
2. Align the sleeve with the medial inside of
positioning plate on the stabilizer bar;
3. Install the fixing plate of stabilizer bar as per the
order as shown in Fig.
stabilizer bar
Front
Fixing plate of stabilizer bar
To Next Page
Loading...