Alarm and Indication System
T-13
Removal/installation of combination
instrument
1. Disconnect battery negative cable;
2. Pull down the adjusting handle of tilting
steering wheel and press down the steering
wheel;
3. Remove in the order indicated as in the Table;
4. The installation procedure is in reverse order
with that of removal;
1 Screw
2
Barrel and combination instrument
guard
3 Screw
4 Connector
5 Combination instrument
Essentials to removal of combination
instrument
1. When removing the combination instrument,
cover the steering column to prevent damage
on the instrument.
Disassembly/assembly of combination
instrument
Attention:
If the combination instrument comes off or the PCB
is damaged, the system will be unable to work
properly and likely to cause failure or abnormal
operation.
1. Disassemble in the order as indicated in the
Table;
2. The assembly procedure is in reverse order of
that of disassembly;
1 Glass cover of combination instrument
2 Upper cover of combination instrument
3 Indicating pointer
4 Combination instrument panel
5 Zero-reset pole
6 Lower cover of combination instrument
Fabric
To Next Page
Loading...