Air-intake System
F-2
Warning
l When the temperature of engine and intake
system is too high, it will burn people.
Therefore, the intake system can be removed
only after the engine and intake system have
been turned off and cooled down.
l Fuel vapor is too dangerous and it ignites
easily, which will cause personal injury or
property damages. Therefore, fuel should be
stored far away from sparks or fire.
l Fuel spill and leakage are dangerous for it
can be easily ignited resulting in personal
injury or property damages. Furthermore,
fuel has negative effects on the skin and eyes.
Therefore, safety regulations must be
followed during operation (refer to Fuel
System - Preparation for Maintenance).
1. Disconnect negative battery cable.
2. Remove with sequence indicated in the figure.
3. Install in reversed order of removal.
1 Air intake hose assembly
2 Air filter assembly
3 Air intake flow sensor
4 Resonance Chamber assembly
5 Air Duct assembly
Removal/Installation of Accelerator Pedal
1. Remove with sequence shown in the figure；
2. Installation sequence:
7 6 3 2 5 4 1
1 Wiring harness of accelerator pedal
2 Bolt
3 Bracket assembly
4 Bolt
5 Accelerator pedal
6 Bolt
7 Check bracket of accelerator pedal
Caution:
Insert the wiring harness to the accelerator pedal
carefully and don’t make the joint crooked.
To Next Page
Loading...