Wiper and washer
T-17
Check of oil pressure switch
1. Confirm that the oil pressure warning light is lit
when the ignition switch is in the ON position;
2. Confirm that the oil pressure warning light
goes off when the engine starts. If the oil
pressure warning light keeps lit, check the oil
pressure warning light and relevant harness. If
the oil pressure warning light and relevant
harnesses are in normal condition, check the oil
pressure. If the oil pressure is normal, replace
the oil pressure switch.
Removal/installation of horn
1. Remove the negative cable of battery;
2. Remove the front bumper;
3. Disconnect the connection of horn connector;
4. Remove the bolt;
5. Remove the horn.
Tweeter
Bolt
Plug
Horn
To Next Page
Loading...