Basic system
U-8
A/c compressor installation instruction
1. when replacing the a/c compressor, discharge
part of compressor oil from the new a/c
compressor.
discharging quantity: 160ml (160cc, 5.40fl oz)
(compressor oil discharged from the used
compressor)
Condenser removal/installation
1. disconnect the negative battery cable.
2. drain refrigerant from the cooling system.
3. remove the front bumper.
Attention
If moisture or impurity enters the cooling
recirculation system, cooling capability will be
reduced and abnormal noise will occur. Always plug
all open joints immediately after removing any
cooling recirculation system component to keep
moisture or impurity out of the system.
Do not allow compressor oil to flow out. If the a/c
compressor operates in lack of oil, abnormal noise
and scuffing of a/c compressor will occur.
4. remove in order as shown in the table.
5. install in reverse order as of removal.
6. perform the cooling system performance test.
1 High-pressure hose assembly (high pressure)
2 Pipe subassembly (low pressure)
3 Condenser assembly
Condenser installation instruction
1. when installing a new condenser, add a
supplement quantity of atmoscu 10 compressor
oil into the condenser inlet.
supplemental quantity: 30ml (30cc, 1.0 fl oz)
Condenser inspection
1. check for cracks, damage and oil leakage. If
any, replace the condenser.
2. inspect vanes for clogged by dust. If clogged,
clean any dust.
3. check for bent vanes. If any vane is bent,
straighten it with a flat head screwdriver.
Cooling system pipelines removal/ installation
1. disconnect the negative battery cable.
2. draw refrigerant from the system.
3. remove the front bumper.
Attention
If moisture or impurity enters the cooling
recirculation system, cooling ability will be reduced
and abnormal noise will occur. Always plug all open
joints immediately after removing any cooling
recirculation system component to keep moisture or
impurity out of the system.
Do not allow compressor oil to flow out. If the a/c
compressor operates in lack of oil, abnormal noise
and scuffing of a/c compressor will occur.
4. remove in order as shown in the table.
5. install in reverse order as of removal.
6. perform the cooling system performance test.
To Next Page
Loading...