Use of Engine Service Platform
17
Use of Engine Service Platform
Upper Service Platform of Engine
1. Fit the support sliding arm of special tools at the exhaust side of cylinder block and
tighten the fastening bolt (as shown in Fig.).
2. Install special tools as per the position shown in Fig.
3. Adjust the fastening bolt and assure that a part of thread in about 20mm (0.79in) is
exposed.
4. Adjust the bolt and nut and enable the support plate and support sliding arm of
special tool to locate on the same level.
5. Tighten the bolt and nut of special tool.
Attention
l The self-lock braking system of engine service platform may become suddenly
ineffective under unbalanced state, e.g. sudden and rapid action during the
upper/lower the engine gets on and off the platform may cause the unbalance of
engine service platform and result in hazard. Thus, during the operation, ensure
the equitability of engine and whole service platform. When operating the
turnover of engine, firmly grip the rotating handle of service platform.
Support sliding arm
Bolt
Fastening nut
Fastening bolt
Bolt
Bolt
Fastening nut
Support plate
To Next Page
Loading...