Wiper and washer
T-11
Cleaning of windshield washer nozzle
Insert an needle or similar tool into the nozzle of
washer and clean it by pulling forward/backward.
Remove the hose from the nozzle if the nozzle still
plugged after the cleaning. Assure there is sufficient
cleaning fluid and then turn on the washer switch to
wash the interior of hose.
Removal/installation of windshield washer
hose
1. Remove engine bonnet acoustic baffle;
2. Partly lift up the right fender;
3. Remove as per the order indicated in the Table;
4. The installation procedure is in reverse order
with that of removal.
1 Snap
2 Connecting pipe
3 Windshield washer hose
Removal/installation of rear wiper motor
1. Disconnect battery negative cable;
2. Remove rear wiper arm and blade (See the
Removal and Installation of Rear Wiper Arm
and Blade)
3. Remove the inner trim panel of back door (See
the Removal of Inner Trim Panel of Back
Door)
4. Remove in the order as shown in Fig.
5. Install in reverse order with that of removal.
6. Adjust rear wiper arm and blade. (See
Adjustment of rear wiper arm and blade)
1 Outer sleeve
2 Connector
3 Bolt
4 Rear wiper motor assembly
Check of rear wiper motor
1. Disconnect battery negative cable;
2. Remove the inner trim panel of back door;
3. Remove the connector of rear wiper motor;
4. The connector B of rear wiper motor is in
connection with the positive of battery and A
with body metal part for the purpose of
grounding;
5. Be sure that the rear wiper motor is properly
operating;
6 Release the grounding wire of A when
operating on the rear wiper motor.
7. Confirm that the rear wiper parked on the Stop
position. If not, replace the rear wiper motor.
To Next Page
Loading...