Power supply system
T-1
Power supply system
Precautions to fuse use
After the burn-out reason identified and
troubleshooting performed, replace the
burn-out fuse by a specified type of fuse.
Failure to troubleshooting prior to
replacement may make the fuse be blown
again.
Removal/installation of main fuse
1. Remove the negative cable of battery;
2. Remove the cap of main fuse box;
3. Remove as per the order as specified in the
table.
4. The installation procedure is in reverse order
with that of the removal.
1 Nut
2 Main fuse
Removal/installation indoor fuse box
1. Remove the negative cable of battery;
2. Remove the left front interior trim at the driver
side;
3. Remove as per the order indicated in the Table.
4. The installation procedure is in reverse order
with that of the removal.
1 Nut
2 Snap
3 Harness connector
Removal/installation of ignition switch
1. Remove the negative cable of battery;
2. Remove the steering column cover;
3. Remove as per the order indicated in the Table.
4. The installation procedure is in reverse order
with that of the removal.
1 Connector
2 Screw
3 Ignition switch
Check of ignition switch
1. Remove the negative cable of battery;
2. Remove steering column cover;
3. Disconnect the connector of ignition switch;
4. Check, with an ohmmeter, the continuity
between the terminals of ignition switch. If it
fails to meet the technique requirements,
replace the ignition switch.
Continuity
To Next Page
Loading...