HAIMA 7 - Adjustment of Front Doors; Disassembly;Assembly of Rear Doors; Disassembly Instructions of Harness Connector; Assembly Instructions of Harness Connector

Doors
S-5
Adjustment of front doors
1. Measure the clearance between the front door
and bodywork;
l If abnormal, loosen the mounting bolt of door
hinge or the mounting screw of door lock latch,
and readjust the door position.
2. Fasten bolts.
Disassembly/assembly of rear doors
1. Disconnect the negative cable of battery;
2. Remove the hinge bolt of rear door and
dismantle the connection of front hinge;
3. Remove the limiter bolt of rear door and
dismantle the limiter connection;
4. Dismount as indicated in the following Table;
5. The installation is in the reverse order with the
removal;
6. Adjust the rear doors (See——Adjustment of
Front Doors);
1
Harness connector
(See Disassembly Instructions )
(See Assembly Instructions )
2 Rear door hinges
3 Rear doors
4 Rear door limiters
Disassembly instructions of harness
connector
1. Pull out the snap lock;
2. Disconnect the connection.
Assembly Instructions of harness
connector
1. Insert the snap lock;
2. Fix the connector;
3. Press again the snap lock.
Disassembly/assembly of rear doors
1. Let the door glass drop to the lowest position;
2. Disconnect the negative cable of battery;
Clearance:
Section view A-A
Section view B-B
Hinge bolt
Hinge bolt
Limiter bolt
Snap lock
Connector