Front suspension
R-10
Removal/installation instructions of front cross-beam
1. Remove the front cross-beam elements;
2. Remove the front exhaust pipe (Refer to F
Removal/Installation of Exhaust System);
3. Remove the engine support beam (Refer to B,
Essentials to the Removal of Engine Support
Beam);
4. Undo the linkage between the engine suspension
1# and front cross-beam;
5. Undo the linkage between the lower swing arm,
steering mechanism and knuckle;
6. Undo the linkage between the control
connecting rod and damping column assembly;
7. Remove the front cross-beam and lower swing
arm from the vehicle;
8. Remove the steering and draw bar (Refer to N,
Removal/Installation of Steering and Draw Bar);
9. Remove the lower swing arm of front
suspension (Refer to R, Removal/Installation of
Lower Swing Arm of Front Suspension);
10. Remove the cross stabilizer bar;
11. Remove in the order as shown in the Table;
12. Install in the reversing order of removal;
13. Check the alignment of front wheels. Adjust it if
necessary.
1
Front stabilizer bar: Refer to R, Removal/
Installation of Front Stabilizer Bar
2
Front suspension cross-beam assembly
3
Front cross-beam elements
To Next Page
Loading...